How to I save/load state using my gamepad?
2 posters
Page 1 of 1
How to I save/load state using my gamepad?
Hi!
I've searched it all over the internet and I have no clue about how to set my gamepad to save/load states.
Any help is welcome
Thanks!
I've searched it all over the internet and I have no clue about how to set my gamepad to save/load states.
Any help is welcome
Thanks!
catcrategames- Messages : 2
Date d'inscription : 2021-06-06
althegr81 likes this post
Re: How to I save/load state using my gamepad?
You have to hold select\hotkey and the save button on the controller which is different according to the system you are using. You can consult the manual in install directory.
My installation and manual location is: C:/RetroBat/emulationstation/.emulationstation/notice.pdf
My installation and manual location is: C:/RetroBat/emulationstation/.emulationstation/notice.pdf
althegr81- Messages : 1
Date d'inscription : 2023-02-26
Lorenzolamas likes this post
Similar topics
» Save state support for PCSX2 and Dolphin via gamepad
» save and load stopped working
» [RESOLVED] ERROR TO LOAD SAVE GAMES
» Save states issue. "No save state found" after Retrobat is exited.
» Only gamepad detected as Gamepad 2
» save and load stopped working
» [RESOLVED] ERROR TO LOAD SAVE GAMES
» Save states issue. "No save state found" after Retrobat is exited.
» Only gamepad detected as Gamepad 2
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum