RETROBAT Official Board
Would you like to react to this message? Create an account in a few clicks or log in to continue.

How to pass/create controller deadzones?

2 posters

Go down

How to pass/create controller deadzones? Empty How to pass/create controller deadzones?

Post by pdx_gamer 06/12/20, 06:49 am

Hi all-
When I run cemu externally (separate install), the xbox 360 controller works fine. Cemu has a deadzone setting set to 25% which works fine w/ my controller.

When starting from ES, the controller config is overwritten, and  the deadzone setting is set to 15% (my dirty controller needs 25%) and I keep walking off mountains, etc (LOL).

How do I get the deadzone to stick?
thanks for any info.
pdx_gamer
pdx_gamer

Messages : 3
Date d'inscription : 2020-12-06

Back to top Go down

How to pass/create controller deadzones? Empty Re: How to pass/create controller deadzones?

Post by pdx_gamer 06/12/20, 08:07 am

Workaround- I edited the cemu/controllerprofiles/controller0.txt file and set the deadzone to 0.25. I saved, then set the permissions to read-only. The controller seems to work fine now, but where so I set it on the emulation station config?
pdx_gamer
pdx_gamer

Messages : 3
Date d'inscription : 2020-12-06

Back to top Go down

How to pass/create controller deadzones? Empty Re: How to pass/create controller deadzones?

Post by Lorenzolamas 06/12/20, 05:58 pm

hello,

OK good news, the deadzone is hardcoded. Each pad is different, your solution is good i think.

ps: choose an avatar Wink
Lorenzolamas
Lorenzolamas
Admin

Messages : 2650
Date d'inscription : 2019-07-28

Back to top Go down

How to pass/create controller deadzones? Empty Re: How to pass/create controller deadzones?

Post by Sponsored content


Sponsored content


Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum